Step #3 - Pull the tucks tight as you go. Make subsequent tucks in the same manner between the 3rd and the 4th, 6th and 7th strand pairs. Pull the tail through until “A” and “B” align. Open up “B” with a fid tool and pass the bitter end and tail through the ropes completely. Step #2 - To mark the tuck points in the area between points “B” and “C” mark the 3rd, and 6th pics (Reference Generail Splicing Tipes on ). Continue down the rope and additional three fid lengths. Form the desired eye – size and place a mark opposite “A”, this is mark “B”. Step #1 - Mark rope three fid lengths from the bitter end. Step #8 - We recommend lock stitching and whipping the splice. The tapered tail will withdraw into the rope. Smooth the rope away from this point up the standing part of the line. Step #7 - Firmly grasp the rope at the point where “A” and “B” meet. Remove the tool and the tape wrap from the exposed tail. Step #6 - Re-tape the bitter end and attach it to your splic-ing tool. Step #5 - Cut and remove these strands back to the bitter end. (A pic is the V shaped strand pair you can see as you look down onto the top of the rope.) Mark this pair and continue down the rope marking every 5th pair as shown. Step #4 - From point “A” counting toward the bitter end, count out 6 pics. Step #3 - From mark “B”, measure down the rope 3 full lid lengths, this will be mark “C”. Step # 2 - Form the desired eye size and mark the point opposite “A”. Put a single wrap of tape at the bitter end (A fid length equals 21 times the diameter of the rope or 7 times the circumference.) Step #1 - From the rope’s bitter end measure back two full fid lengths, and place a mark on the rope. Masking Tape Felt Tip MarkerSplicing Fids SPLICING GUIDEGENERAL-SPLICING TIPS TOOLS REQUIRED To avoid kinking, coil rope in figure eight for storage or take on deck. A “Pic” is the V-shaped strand pairs you see as you look down the A “Fid” length equals 21 times the diameter of the rope (Ref Fid Chart).3. Before starting, it is a good idea to read through the directions so you understand the general concepts and principles of the splice.Ģ. In addition, some shrinkage has probably occurred making this splice the most difficult to perform.ġ. Through use and exposure to the elements, the fibers in a used rope have probably lost some of their original strength. Soaking the section of used rope to be spliced in water will loosen and lu-bricate the fibers and make the splice easier to perform. use the same material as the cover braid if available, or waxed whipping thread. Trim thread to a one inch length and bury remaining thread and knot into rope.Īs a general rule of thumb, if you whip the rope, do so for a length a rope diameter and hold it in place with cross-stitching. Cut off thread leaving an eight inch length and double knot as close to rope as possible. Using same material as cover braid if available, or waxed whip-ping thread, start at bottom leaving at least eight inches of tail exposed for knotting and work toward the eye where you then cross-stitch working back toward starting point. To cross-stitch, mark off six to eight rope diameters from throat in one rope diameter increments (stitch length). Seize by whipping or stitching the splice to prevent the crossover from pulling out under the unbalanced load.
0 Comments
Leave a Reply. |